Garage Door Opener Installation in Burlingame, CA
Quiet belt drives, wall-mount units and battery backup · Burlingame, San Mateo, Millbrae and San Bruno
Open 7 AM to 10 PM. The price is confirmed on site before any work starts.
Garage door opener installation starts with the door, not the motor. California law now requires a battery backup and a sensor that sends a closing door back up. Condor of Burlingame sizes the opener to your door, installs the safety sensors and sets them to reverse.
The business address is 210 Windermere Rd in Hillsborough, and the phone is answered 7 AM to 10 PM.



Garage Door Opener Installation: What California Requires
State law sets three rules for any opener installed in a home. Check each one before you compare brands.
- Battery backup. Since July 1, 2019, an installed opener must keep working through a power outage (Health and Safety Code 19892).
- Reversing sensor. The opener must need an optical sensor, a tactile edge sensor or a similar device to run, one that sends a closing door back up (Health and Safety Code 19890).
- New door, old opener. A replacement door may not be connected to an existing opener that lacks the backup or fails the reverse test.
The door trade group DASMA adds two height limits. Photo eyes belong no higher than six inches above the floor, and the wall button belongs at least five feet up, out of a child's reach.
Pick the Drive and the Mount
Belt drive. A belt moves the trolley instead of a chain, which makes the unit quieter. Choose it if a bedroom, an office or a room above shares the garage. On the bay side, a belt also has no steel chain to rust in damp air.
Wall-mount unit. This motor sits beside the door instead of on a ceiling rail. It can suit a low or crowded ceiling and frees the space overhead for storage.
Measure from the top of the closed door to the ceiling, and send us the number. Ask about remotes that use a rolling code. DASMA notes that these change the code after every use.
A New Motor Will Not Fix a Heavy Door
If the door feels heavy or takes two hands, it is probably out of balance. DASMA says openers are built to lift balanced doors. A bigger motor only hides the fault until something else gives.
Fix the cause first. A spring repair restores balance, cable repair levels a crooked door, and track repair frees a door that rubs. If the old motor still runs but misbehaves, ask about opener repair before you replace it. Buying a door as well? See new garage door installation.
What an Installation Visit Covers
- Measure. Door size, headroom and side room.
- Check the door. Balance, rollers, cables and tracks.
- Confirm the price. You hear it at the door, before work starts.
- Mount the unit. Opener, wall control and the sensors.
- Test the reverse. The door must stop and go back up.
We install in Burlingame, San Mateo, Millbrae and San Bruno. The price page lists the owner's starting prices. Use the contact page to send the door size, the ceiling height and photos.
Starting Prices — Garage Door Opener Installation
- Diagnostic Service Call $0 with a completed repair
- $0
Opener installation has no fixed starting price on this page. The unit, the door size and the mount shape the price, and Condor confirms it on site before any work starts.