Hillsborough, CA · Open 7 AM to 10 PMCall: (650) 532-7517

Garage Door Cable Repair in Burlingame, CA

Cables and drums replaced as a set · Burlingame, San Mateo, Millbrae and San Bruno

Open 7 AM to 10 PM. The price is confirmed on site before any work starts.

Garage door cable repair fixes a door that hangs crooked, jerks on the way up or will not lift. A steel cable runs from each bottom corner of the door to a drum on the spring shaft. When one frays or slips off its drum, that side of the door drops.

Condor of Burlingame replaces the cables and drums as a set and re-tensions them, so the door lifts level again. Condor lists its address as 210 Windermere Rd, Hillsborough, and the hours as open 7 AM to 10 PM.

Loose steel cable loops beside a cable drum above a garage door track
Two technicians on stepladders working at the tracks of a sectional door
Technician on a stepladder under the spring shaft of a door with small windows

Garage Door Cable Repair: Signs to Report

Look from the floor, with the door shut or stopped where it is. Tell us which of these you see:

  • A bottom corner has dropped below its partner on the other side.
  • A cable hangs loose, or sharp wire ends stick out near a bottom bracket.
  • A cable has jumped off the drum above the door and left loops on the shaft.
  • The door jerks, rattles or stops a foot or two above the floor.
  • You hear the motor, yet the door hardly rises.

Stop using the door. Do not press the wall button again, and do not pull the red release cord on a door that hangs open. A side held up by one cable can drop. The garage door trade group DASMA warns that frayed cables can break and that high spring tension makes their replacement a job for a trained technician.

What Happens on a Cable Visit

  1. Make it safe. A technician secures the door first so it cannot move.
  2. Look at the whole system. Both cables, both drums, the bottom brackets, the springs, the rollers and the track.
  3. Confirm the price. The number is given at the door, ahead of any repair.
  4. Replace and re-tension. The cables and drums go in as a set.
  5. Test the lift. The door should rise level and close evenly.

A bad cable often means another part has slipped. A bent track can snag a roller. A track repair or a spring check may be part of the visit. A section creased by a leaning door is a panel replacement question. If the door is stuck shut, call about an emergency repair.

Why Cables Wear on the Bay Side

A lift cable is bare steel rope. It ends at the lowest point of the door, where dust and damp collect. The National Weather Service explains that summer fog forms when warm, moist air moves over cold water. On the Peninsula, that fog arrives in the afternoon and lingers into the morning.

Once a year, look at the bottom end of each cable from the floor. Rust stains, a kink or wire ends sticking out are reasons to book a visit. A clean cable can still be worn inside, so a stiff or noisy lift is a reason to call, too.

We take cable calls in Burlingame, San Mateo, Millbrae and San Bruno. Read the price list first, or send your address and photos through the contact page.

Starting Prices — Garage Door Cable Repair

Garage Door Cable Replacement per cable
From $150
Diagnostic Service Call $0 with a completed repair
$0

The amount shown is where a cable job begins. A damaged drum or bracket changes the scope, and the full price is confirmed on site before any work starts.

Confirm My Price All prices →

Cable Repair Questions

Can I swap a frayed cable myself?
We advise against it. The cables and the bottom brackets carry spring tension, and the industry group DASMA says only a trained technician should replace or adjust them. Keep people clear of the door and call (650) 532-7517.
Why are the drums replaced with the cables?
A worn or bent drum can pinch a new cable. Condor replaces both as a set and re-tensions them, so each side of the door lifts at the same pace.
What does cable work cost?
Cable replacement starts at $150 per cable. The diagnostic call is $0 with a completed repair. The price for your door is confirmed on site before any work starts.
Contact Us

Contact Condor of Burlingame

Tell us what your door is doing and we'll call you right back. Starting prices are on our pricing page; the exact price depends on the door, parts, and size, and you get it on site before any work starts.

Condor Garage Door Repair Expert of Burlingame
210 Windermere Rd
Hillsborough, CA 94010

Phone: (650) 532-7517
Email: info@condorgaragedoorrepairexpert.com
Hours: Open 7 AM to 10 PM, 7 days a week

Book a Visit ☎ Call (650) 532-7517

☎